The Archive · 1938

Robot Worker

The industry was based on thermoplastic products. The products of the "new" plastics era were of the thermo-setting class, but during the last few years development has again favoured thermoplastics. An important reason, Dr. Yarsley said, is the rapid advance in injection-moulding. This method, which has been called one of the major developments of the plastics age, can be applied only to thermoplastic materials and machines are now available in which the entire operation is automatic. A large machine will handle up to half a ton of material in a forty-hour week, and that means an extraordinary output of such small objects as buttons and combs.

At present—and here the process differs from pressure moulding—the injection method is limited to small articles of the nature of zip fasteners and spectacle frames. Nevertheless, remarkable advances are promised. The principal injection material in this country is still cellulose acetate plastic

Text read from the printed page and cleaned; old type leaves the occasional error.

Your account